Onewheel GT Maghandle Replacement

Written By: Justin Velasquez

Difficulty: Easy

Steps: 2

Time Required: 10 minutes

Introduction

For your safety, power off your Onewheel GT prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel GT during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1   Remove the fender/delete screws and fender/delete

  • Remove all four (4) screws using a TP25 bit.
  • Note: Keep screws organized as they are easy to mix up and/or lose.
  • To remove the fender/delete, apply pressure to each side of it, near the axle carriers, and pull it up and away from the Onewheel™.
The Onewheel GT fender delete.

Step 2   Remove the maghandle screw and maghandle

  • Remove the one (1) screw using a 3 mm hex bit.
The Onewheel GT Maghandle.

© 2024 FixMyPEV ™  All Rights Reserved.