Onewheel Pint X Footpad Replacement

Difficulty: Easy

Steps: 3

Time Required: 15 minutes

Introduction

If your Onewheel Pint X footpads are damaged, failing, or you’re just ready for a new set, use this guide to help you swap them out and get back to riding!

For your safety, power off your Onewheel Pint X prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel Pint X during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1 Remove the bottom front and rear bumper screws

Remove all eight (8) screws using a TP20 bit.
Note: DO NOT remove the front bottom bumper screws closest to the tire.

Step 2 Remove the top footpad screws

Remove all four (4) screws using a TP20 bit.

Step 3 Remove the footpads

Caution: For the front footpad sensor connector, turn (counter-clockwise) only the smaller part of the connector closest to the controller. Turning the entire body of the connector can damage it or your controller.
Note: If you are unable to remove the footpad sensor connector using your fingers, you may use a Future Motion™ footpad connector wrench or a pair of long nose pliers (be gentle).