Onewheel XR Bumper Replacement

Written By: Justin Velasquez

Difficulty: Easy

Steps: 3

Time Required: 20 minutes

Introduction

If your Onewheel XR bumpers are worn down, broken, or you’re just ready for a new color, use this guide to swap them out and keep your investment protected!

For your safety, power off your Onewheel XR prior to disassembly. This reduces the risk of electrical malfunctions and/or damage during the replacement process.

Note: Altering or damaging any component of your Onewheel XR during disassembly/reassembly may render your existing warranty void or lead to refusal of non-warranty service at the discretion of Future Motion, Inc. (the creators of Onewheel).

Step 1   Remove the bottom bumper screws

  • Remove all twelve (12) screws using a 1/8″ hex bit.
  • Note: Keep screws organized as they are easy to mix up and/or lose.

Step 2   Remove the top footpad screws and footpads

  • Remove all four (4) screws using a 1/8″ hex bit.
  • Caution: For the front footpad sensor connector, turn (counter-clockwise) only the smaller part of the connector closest to the controller. Turning the entire body of the connector can damage it or your controller.
  • Note: If you are unable to remove the footpad sensor connector using your fingers, you may use a Future Motion™ footpad connector wrench or a pair of long nose pliers (be gentle).

Step 3   Remove the top bumper screws and bumpers

  • Remove all four (4) screws using a 1/8″ hex bit.
  • To remove the front bumper, pull it toward the nose of the Onewheel™. DO NOT pull it straight down.

© 2024 FixMyPEV ™  All Rights Reserved.